There are many different ways you can connect pipes, valves and fixtures. However, most plumbers tend to go for a compression fitting. This is the easiest way to connect a pipe to a valve or fixture or another pipe.

They are also the preferred choice because they are extremely effective when it comes to creating a tight and secure seal. Nevertheless, it is worth bearing in mind the fact that they are not a lifetime solution.

This means that you will need to replace your compression fittings from time to time. This is why it is important to know how to install them.

Considerations

The first thing you need to do is determine whether the compression fitting in question is suitable for your application. The good news is that they are beneficial in most areas, even those that are awkward or confined, such as under the sink.

There are so many fittings available today after all. If you look at these BSP stainless steel pipe fittings, you will see what we main. In addition to this, you also need to bear in mind the fact that you must apply your compression fitting to a joint that is not going to move once it has been made.

A lot of people consider utilising this piece in order to lengthen their pipes. This is possible but it is not recommended. Why? It is quite simple; there is no mechanical support offered by a compression fitting.

Finally, you must make certain that the compression fitting is being fitted to a straight section of pipe. You will find it extremely tough to do so if there is a bend close to where the compression fitting is supposed to be placed.

Getting the parts

Now, once you have assessed the situation it is time to acquire your parts. You will be able to easily locate compression fittings. Most hardware stores will sell them. However, you don’t even need to leave the house if you don’t want to.

Compression fittings are easily accessible over the internet. The only thing you need to do is make sure that the buyer is a credible one. The last thing you want is to receive used compression fittings!

Installing

Once you have acquired everything you need it is time to begin the installation process. This starts by placing the compression ring on the pipe. In order to do this all you need to do is slip the end of the compression ring onto the part of the pipe which is going to be connected to the valve, fixture, or other pipe.

Next, you are going to insert the pipe into the other piece. Once this is done you now need to tighten the compression nut. Begin by doing this with your fingers but then finish off with a pair of pliers to ensure maximum security is achieved.

Don’t forget to check the job has been done properly by turning on your fluid supply and checking for any leaks.

Follow this guide and you simply can’t go wrong! Don’t forget; you need to change your compression fittings every so often. This is not a solution that is going to last you forever.